Diagbox telemetry

[mfc]

as I had already written in a previous post, to enable the listening mode:
AT H1
AT D1
AT CAF0

to listen all the messages from the 6xx addresses:
AT MR 06

to listen all the messages from the 4xx addresses:
AT MR 04

to listen a specific message address (e.i. 0x488):
AT CF 488
AT CM FFF

on the diagbox tools, there is a menu like "personalized parameter reading" in which you can select which value to read continuously
if you need it, tomorrow, I can send you a screen shot of this menu...