Diagbox telemetry

[darkjojo78]

as I had already written in a previous post, to enable the listening mode:
AT H1
AT D1
AT CAF0

to listen all the messages from the 6xx addresses:
AT MR 06

to listen all the messages from the 4xx addresses:
AT MR 04

to listen a specific message address (e.i. 0x488):
AT CF 488
AT CM FFF

on the diagbox tools, there is a menu like "personalized parameter reading" in which you can select which value to read continuously
if you need it, tomorrow, I can send you a screen shot of this menu...

I received my cable today, to connect the diagbox and the elm327. I made custom measurements with the diagbox and monitor the bus can with elm327 on the engine calculator. Diagbox uses the 6A8 header for engine calculator

regime moteur / engine rpm
6A8 5 04 21 C0 80 01

température calculateur/ calculator temperature
6A8 5 04 21 CB 80 01

température air extérieur / outside air temperature
6A8 5 04 21 C2 80 01

température eau / water temperature
6A8 5 04 21 C0 80 01

température huile / oil temperature
6A8 5 04 21 C2 80 01

position pédale accélérateur / accelerator pedal position
6A8 5 04 21 CA 80 01