Diagbox telemetry

[darkjojo78]

as I had already written in a previous post, to enable the listening mode:
AT H1
AT D1
AT CAF0

to listen all the messages from the 6xx addresses:
AT MR 06

to listen all the messages from the 4xx addresses:
AT MR 04

to listen a specific message address (e.i. 0x488):
AT CF 488
AT CM FFF

on the diagbox tools, there is a menu like "personalized parameter reading" in which you can select which value to read continuously
if you need it, tomorrow, I can send you a screen shot of this menu...

I received my cable today, to connect the diagbox and the elm327. I made custom measurements with the diagbox and monitor the bus can with elm327 on the engine calculator. Diagbox uses the 6A8 header for engine calculator

regime moteur / engine rpm
6A8 5 04 21 C0 80 01

température calculateur/ calculator temperature
6A8 5 04 21 CB 80 01

température air extérieur / outside air temperature
6A8 5 04 21 C2 80 01

température eau / water temperature
6A8 5 04 21 C0 80 01

température huile / oil temperature
6A8 5 04 21 C2 80 01

position pédale accélérateur / accelerator pedal position
6A8 5 04 21 CA 80 01

[darkjojo78]

on décortique la ligne de commande custom init
at sp 6 pour la sélection du protocole iso 15765-4 can (11 bit id, 500 kbaud)
at sh 6a8 pour sélection de l'en-tête
at fc sd 30 00 00 flow control set data
at fc sm 1 flow control set mode
at cra 688 set the can rx addr
81 pour se connecter au calculateur moteur
10c0

après essai sa fonctionne pas, mais j'ai peut être trouves le problème qui viendrait de la commande at fc sd 30 00 00. Sur ma 208 avec le diagbox il envoi la commande 6a8 30 00 05, je vais remplacer le 30 00 00 par 30 00 05

nouvelle custom init
atsp6\natsh6a8\natfcsh6a8\natfcsd300005\natfcsm1\n atcra688\n81\n10c0